Specification

Boiling Water Resistance :

 

Max Increase

Thickness increase

Appearance

Unit

 

%, max

%, max

Grade

B S EN 438-2

 

10

12

min. 4

Test Result

 

7.5

8.5

-

Resistance To Surface Water :

Unit

 

Rev

B S EN 438-2

 

min. 350

Test Result

 

550

Resistance To Scratching :

Unit

 

N

B S EN 438-2

 

min. 2

Test Result

 

2.5

Resistance To Dry Heat at

180C :

 

Reagent 1 & 2 :
Reagent 3 & 4 :

Unit

 

 

Grade

Grade

B S EN 438-2

 

 

min. 5

min. 4

Test Result

 

 

5

5

Resistance To Dry Heat at 180C :

 

Appearance: Gloss

Appearance: Others

Unit

 

Grade

Grade

B S EN 438-2

 

min. 3

min. 4

Test Result

 

4

5

Resistance To Cigarette

Burn:

Unit

 

 

Grade

B S EN 438-2

 

 

min. 3

Test Result

 

 

4

Dimensional Stability at 20C :

Unit

 

Length %,

Thickness %

B S EN 438-2

 

max. 0.55,

max. 1.025

Test Result

 

0.4,

0.85

Resistance To Cracking :

Unit

 

Grade

B S EN 438-2

 

min. 4

Test Result

 

5

Dimensional Stability at

Deviated Temperature :

Unit

 

Length %,

Thickness %

B S EN 438-2

 

max. 0.375,

max. 0.625

Test Result

 

0.25,

0.50

Resistance To Impact :

Unit

 

N

B S EN 438-2

 

min. 20

Test Result

 

30

Resistance To Steam :

Unit

 

Grade

B S EN 438-2

 

min. 4

Test Result

 

-

Resistance To Color Change :

 

Xenon Arc Light :
Enclosed Carbon Arc Light :

Unit

 

Grade

Grade

B S EN 438-2

 

min. 5

min. 5

Test Result

 

5

5

Use & Care Guildline

Before bonding, always ensure that surface is leveled and free from any type of oil, excess moisture, dust, grease & other contaminants

Ensure that no air gap or air bubbles remain in between the laminate and the surface during alignment and pressing

To avoid crack, it is recommended to NOT to cut at 90o angle. DO make a rounded cut at the corner after fixing the laminate.

For proper bonding, the pasted portioned must be kept under sufficient pressure for a period of 6 - 12 hours depending on surface and atmospheric conditions.

Apply a coat of adhesive evenly on the surface that requires bonding with help of brush or paint roller.

For cleaning, use clean, damp, non abrasive cotton cloth and mild liquid detergent or household cleaner. Then rinse with clean water, using clean, non abrasive cotton cloth.

 

Once the adhesive applied attains tackiness ( around 20 - 40 minutes ), the laminate should be place on the surface, accurately aligned and press down firmly to ensure proper bonding

DO  NOT flood the laminate with water especially near seams, since water can penetrate and cause the substrate to swell. Dry the surface with soft, clean, non-abrasive cotton cloth.

 

COPYRIGHT © 2017 ALCA  ALL RIGHTS RESERVED

Back To Top